2004 Arctic Cat ATVs factory service and repair manual, Page 460Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 460

11Install the wheels and tighten to 5.5 kg-m (40 ft-lb) 12Remove the ATV from the support stand Drive Axles REMOVING DRIVE
securing the hex nut; then remove the hex nut and rubber washerRelease the brake lever lock 10Install the brake calipersSecure
with the cap screws tightened to 2.8 kg-m (20 ft-lb) 5 Remove the two brake calipers (right side only)I NOTE: Do not allow
the brake calipers to hang from their cablelhose A CAUTION The calipers should be supportedIf the calipers are allowed to