2004 Arctic Cat ATVs factory service and repair manual, Page 461Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 461

W NOTE: Never reuse lock nutOnce lock nut has been removed, it must be replaced with new lock nut W NOTE: It is not necessary
from its hose he caliper should be supportedIf the caliper allowed to hang from its hose, damage may occur REMOVING FRONT
DRIVE AXLE (4x4 Models) 1Secure the on support stand to elevate the wheels6Slide the hub whrake disc out of the steering
knuckle and set aside 7Remove the tie rod from the steering knuckle Make sure the ATV is solidly supported on the support
stand to avoid injury 2Pump up the hand brake; then engage the brake lever lock 3Remove the wheel 4Remove the cotter pin