2004 Arctic Cat ATVs factory service and repair manual, Page 463Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 463

WNOTE: The large grease pack is for the inner drive axle bearing and boot assembly 9Slide the new outer boot onto the shaft
the small clamp from the shaft ASSEMBLING AXLES Install the inner boot with the small clamp making sure the ends of the clamp
are positioned correctlyATV-I 048 continue with step 7 rn NOTE: At this point if the outer boot is damaged, 7Using side-cutters
(or suitable substitute) remove both outer boot clamps from the shafiNote the position of the different-sized clamps for
assembling purposes rn NOTE: The boot is positioned correctly when the small end of the boot seats down into the recessed
groove2Using the boot clamp pliers, secure the small clamp of the inner boot- ATV-I 048 8Apply grease from the kit into the
knuckles and the new outer bootPage: 463 Arctic Cat ATV 2004 -All Models 3Apply grease from the kit onto the bearing ring