2004 Arctic Cat ATVs factory service and repair manual, Page 464Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 464

WNOTE: The large grease pack is for the inner drive axle bearing and boot assembly 7Slide the boot over the housing; then
axle into place in the gear caseW NOTE: To assure proper seating of the axle, give it light pull; the axle should remain
"clipped" in place Swing the knuckle up and onto the drive axle; then place the knuckle into place in the upper A-armSecure
the knuckle to the A-arm with cap screw and new lock nutTighten to 4.8 kg-m (35 ft-lb)Place the hub into position on the
axle followed by washer and hex nutTighten the hex nut finger-tight at this timeIf the brake calipers were removed, position
them on the knuckle and secure with existing cap screwsTighten the auxiliav brake caliper cap screws to 2.1 kg-m (15 ft-lb)Tighten
the hydraulic brake caliper cap screws to 2.8 kg-m (20 ft-lb) 6Making sure the marks made during disassembling align, slide