2004 Arctic Cat ATVs factory service and repair manual, Page 465Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 465

6Tighten the hub hex nut (from step 3) to 10.4 kg-m (75 ft-lb); then install and spread new cotter pin making sure each side
to the A-arm with cap screw and new lock nutTighten to 4.8 kg-m (35 ft-lb)3Secure the tie rod to the steering knuckle with
new lock nutTighten securely; then install and spread new cotter pin4Slide the hub whrake disc into position in the steering
knuckle followed by washer and hex nutTighten finger-tight at this time5Install the brake caliper on the steering knuckleTighten
to 2.8 kg-m (20 ft-lb); then pump up the hand brake lever and engage the brake lever lock6Tighten the hub hex nut (from step
4) to 10.4 kg-m (75 ft-lb); then install and spread new cotter pin making sure each side of the pin is flush to the hub nutlPlug
r Rear Suspension REMOVING 1Place the on support stand (positioned just in front of and behind the footrest on each side)
so the wheels are off the floor Make sure the ATV is solidly supported on the support stand to avoid injury 2Remove the rear