2004 Arctic Cat ATVs factory service and repair manual, Page 467Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 467

3Remove the snap ring securing the bearing housing to the axle shaft; then slide the bearing housing off the shaft 6Remove
2Inspect the case for leaks or damage3Inspect splines for wear 4Inspect the seal for damage5Inspect housing mounting bosses
for wear or elongated holes 6Inspect the frame welds for cracking or bending7Inspect the rear drive and plug threads for
stripping or damage5Remove the two cap screws securing each axle housing to the gear caseINote that these cap screws are
33 mm (1.3 in in length for installing purposes 8Inspect the axle bearingsRotate the bearings by hand, and if any roughness