2004 Arctic Cat ATVs factory service and repair manual, Page 468Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 468

2Make sure the rear gear caselaxle housing O-ring is properly positioned; then secure the axle housing to the rear gear case
(40 ft-lb) 3Secure the axle housing to the rear gear case with four 37 mm (1.5 in cap screwsTighten to 4.3-5.3 kg-m (3 1-38
ft-lb)I NOTE: If new gear housing is being installed, tighten the cap screws to 5.1-6.3 kg-m (37-45.5 ft-lb) INSTALLING Maneuver
the axle assembly forward making sure propeller shaft splines engage properly and the final drive boot is positioned over
the drive housingPlace the rear of the swing arm(s) into position on the axle housings and case; then secure with four cap