2004 Arctic Cat ATVs factory service and repair manual, Page 469Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 469

3Place the shock absorber into the frame mounts and secure using the cap screws and hex nuts tightened to 4.8 kg-m (35 ft-lb)
test riding Rear Gear Case (400 FISl500 Models) REMOVING Care should be taken not to damage or kink the brake cablelhose
when installing the calipers 1Remove the left-side rear A-arms (see Rear A-Arms in Section 7)2Remove both of the rear drive
axles (see Drive Axles in this section) 3Remove the four cap screws securing the engine output shaft to the rear gear case
input flange 5Place the gear case panel into position and secure with the three cap screwsTighten securely 4Remove the two