2004 Arctic Cat ATVs factory service and repair manual, Page 470Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 470

c AT THIS POINT For servicing the input shaft, pinion gear, needle bearing, and axle seal on FIS models, see Front Differential
lock nutsTighten to 4.8 kg-m (35 ft-lb) 4Remove the brake caliper 3Install the rear drive axles (see Drive Axles in this
section) 4Install the left-side rear A-arms (see Rear A-Arms in Section 7) REMOVING 1Secure the ATV on support stand to elevate
the wheel; then remove the wheel 5Remove the hub assembly6Remove the four cap screws securing the brake disc CLEANING AND
INSPECTING Make sure the ATV is solidly supported on the support stand to avoid injuryI NOTE: Whenever part is worn excessively,
cracked, or damaged in any way, replacement is necessary 2Remove the cotter pin from the nutI NOTE: During assembly, new