2004 Arctic Cat ATVs factory service and repair manual, Page 480Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 480

Secure the two right side swing arms to the frame brackets with cap screws and hex nutsDo not tighten at this timeOn the
then remove the tie rod end from the knuckle Make sure the ATV is solidly supported on the support stand to avoid injury
2Remove the wheel cap from the hub; then remove the cotter pin from the nut 7Remove the cap screws securing the ball joints
to the knuckle 3 Remove the nut securing the hubAccount for washer and hub seal 8Tap the ball joints out of the knuckle;
then remove the knuckle9Remove the lower shock absorber eyelet from the upper A-arm Page: 480 Arctic Cat ATV 2004 -All Models