2004 Arctic Cat ATVs factory service and repair manual, Page 482Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 482

4Secure the lower eyelet of the shock absorber to the upper A-armTighten nut to 4.8 kg-m (35 ft-lb)5Secure the A-arm assemblies
hub 7Install the tie rod end and secure with the nutTighten to 4.2 kg-m (30 ft-lb); then install new cotter pin and spread
the pin to secure the nutI NOTE: During assembly, new cotter pins should be installed 10Place the washer onto the shaft;
then secure the hub assembly with the nutTighten only until snug11Secure the brake caliper to the knuckle with the two cap
screwsTighten to 2.8 kg-m (20 ft-lb) 8Apply grease to hub sealing area and on the drive axle splines; then install the hub