2004 Arctic Cat ATVs factory service and repair manual, Page 484Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 484

10Remove the cap screws and lock nuts securing the A-arms to the frame; then remove the A-armsIIf removing the upper right
to the A-arms with cap screws and new lock nutsTighten to 4.8 kg-m (35 ft-lb)3Tighten the hardware securing the A-arms to
the frame mounts (from step 1) to 4.8 kg-m (35 ft-lb)4Apply grease to hub sealing area and on the drive axle splines; then
install the hub assembly onto the drive axle 6Place the washer onto the drive axle; then secure the hub assembly with the
nutTighten only until snug 7Secure the brake caliper to the knuckle with the two cap screws (right side only)Tighten the
mechanical caliper to 2.1 kg-m (15 ft-lb)Tighten the hydraulic caliper to 2.8 kg-m (20 ft-lb)IEnsure that the brake hose
and brake cable are properly routed and secured to the upper A-arm 8Secure the hub nut (from step 6) to the drive axleTighten