2004 Arctic Cat ATVs factory service and repair manual, Page 494Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 494

Handlebar Grip REMOVING 1Remove the plug from the head of the rivet2Using 118-indrill bit, drill out the rivet3Using compressed
Apply liberal amount of Handlebar Grip Adhesive (pln 0636-071) to the inside of the gripAlign the rivet hole in the grip
with the rivet hole in the handlebar; then align the notch (inside the grip) with the slot in the handlbar and slide the
grip onto the handlebar until it is fhlly seatedWipe off any excess glue; then secure the grip with new rivetInstall the
plug on the head of the rivet 9Place the gas tank into positionSecure with screws and washers Steering Knuckles REMOVING
AND DISASSEMBLING 1Secure the ATV on support stand to elevate the wheel; then remove the wheel10Connect the he1 hose to the
carburetor11Install the left-side panel (see Front FenderlSide Panels in this section); then install the seat (see Seat in
this section)W NOTE: Turn the gas tank valve to the ON position only if starting the engine Make sure the ATV is solidly