2004 Arctic Cat ATVs factory service and repair manual, Page 510Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 510

8Disconnect the wires from the accessory plug (if equipped); then remove the accessory plug from the fender9Remove the fenders
to the frame and footrests and finger-tighten; then tighten the ten fasteners securely4Connect the drive selector linkage
using existing hardwareTighten securely Fender Flares Extensions REMOVING 1Using side-cutter, remove the appropriate plastic
rivetsI NOTE: To remove front extension, first remove the grille; then remove the push nuts securing the extension to the
bumper 2Remove the cap screws securing the extensions or flares to the frame and footrest 3Remove the self-tapping screws
securing the extension to the fenderINSTALLING 5Install the gear shift linkage cover in the left-front fender wellTighten
securely 1Place the flare or extension into positionUsing the Plastic Rivet Setter (pln 0444-056), secure with Plastic Rivets
(pln 0423-046) or suitable substitute 2Secure the extensions or flares with the cap screws and self-tapping screws Page: