2004 Arctic Cat ATVs factory service and repair manual, Page 512Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 512

INSTALLING MUFFLER 1Install the muffler on the frame and into the mufflerlexhaust pipe juncture accounting for all mounting
three-prong connector; then remove the fenderCLEANING AND INSPECTING I NOTE: Whenever part is worn excessively, cracked,
or damaged in any way, replacement is necessary frame and rear fendersAccount for any washers 2Lift the rack upward and remove
from the frameCLEANING AND INSPECTING IWhenever part is worn excessively, cracked, or damaged in any way, replacement is
necessary1Clean all rear rack components with parts-cleaning all rear fender components parts-cleaning solvent and soap and
water solvent 2Inspect all welds for cracking or bending3Inspect threaded areas of all mounting bosses for stripping 2Inspect
side panels, fender extensions, and rear fenders for cracks and loose rivets3Inspect threaded areas of all mounting bosses
for stripping 4Inspect for missing decals andlor reflectorsINSTALLING 1Place the rack into position on the frame; then 4Inspect