2004 Arctic Cat ATVs factory service and repair manual, Page 514Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 514

INSTALLING 1Place the cargo box into position on the frameSecure with cap screws and new lock nutsTighten to 4.8 kg-m (35
are approximately 6.1 (20 ft) from an aiming surface (wall or similar aiming surface)CLEANING AND INSPECTING IThere should
be an average operating load on the ATV when adjusting the headlight aim IWhenever part is worn excessively, cracked, or
damaged in any way, replacement is necessary 2Measure the distance from the floor to the mid-point of each headlight Clean
all cargo box components with soap and waterInspect the cargo box for cracks, tears, and loose mounting hardwareInspect the
welds of the cargo box frame for cracking or bendingInspect the cargo box gate latches for smooth operation 3Using the measurements
obtained in step 2, make horizontal marks on the aiming surface4Make vertical marks which intersect the horizontal marks
on the aiming surface directly in front ofthe headlights 5Switch on the lightsMake sure the HIGH beam is onDO NOT USE LOW
BEAM6Observe each headlight beam aimProper aim is when the most intense beam is centered on the vertical mark cm (2 in below