2004 Arctic Cat ATVs factory service and repair manual, Page 526Get this manual

2004 Arctic Cat ATVs factory service and repair manual, Page 526

Drive Selector (400 FISl500 Models) The automatic drive selector allows the operator to operate in either 2-wheel drive (rear
front differential while the ATV is moving Reverse Shift Lever (Manual Transmission) To shift into reverse gear, stop the
ATV completely and shift the transmission into neutralPull the reverse shift lever fully rearward to the "R" positionWhen
the ATV is in reverse gear, the gearshift pedal will not function 1Handle 2Clip 3Plate 4Lever 5Spring 6Nut 70-Ring 8Axle
9Axle 100-Ring 11Washer 12Cap Screw 13Linkage 14Rod End 15Nut 16E-Ring 17Washer 18Bushing 19Shield 20Screw 21Screw 0738-82
Never shift the ATV into reverse gear when the ATV is moving as it could cause the ATV to stop suddenly throwing the operator
from the ATV REMOVING 1Remove the seat (see Section 8) 2Remove the gas tank (see Section 4)3Remove the three machine screws