2005 Arctic Cat ATVs factory service and repair manual, Page 16Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 16

3Remove the vent plugs; then (if necessary) fill the battery with distilled water to the upper level indicated on the battery4Trickle
rate 5After charging, check fluid level and fill with distilled water as necessary; then install vent plugs A CAUTION Before
installing the battery, make sure the ignition switch is in the OFF position 6Place the battery into position in the ATV
and secure with the hold-down bracket7Attach the vent tube and check the vent tube to make sure it is not crimped or obstructed
in any way and that it is properly routed through and secured to the frame 2501300 10 IGN 15 LIGHTS 10 ACC 10 SPARE 10 LIGHTS
10 HIGH 8Connect cables to the proper terminals: positive cable to the positive terminal (+) and negative cable to the negative
terminal (-)Connect the negative cable last 10 IGN 15 FAN 15 ACC A CAUTION Connecting cables in reverse (positive to negative