2005 Arctic Cat ATVs factory service and repair manual, Page 28Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 28

ValveITappet Clearance (650 V-Twin Valve Adjuster Procedure) To check and adjust valveltappet clearance, use the following
point, the rocker arms and adjuster screws must not have pressure on themI NOTE: Use Valve Gap Adjuster (pln 0444-092) for
this procedure 5Rotate the crankshaft counterclockwise until the TR mark (A) aligns in the timing holeRepeat steps 3-4 for
the rear cylinder 4Place the valve adjuster onto the jam nut securing the tappet adjuster screw; then rotate the valve adjuster
dial clockwise until the end is seated in the tappet adjuster screw 5While holding the valve adjuster dial in place, use
the valve adjuster handle and loosen the jam nut; then rotate the tappet adjuster screw clockwise until friction is felt
ATV2058E 6Align the valve adjuster handle with one of the marks on the valve adjuster dial 6Install the timing inspection
plug 7While holding the valve adjuster handle in place, rotate the valve adjuster dial counterclockwise until proper valveltappet