2005 Arctic Cat ATVs factory service and repair manual, Page 33Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 33

8Install the engine drain plugs and tighten to specificationsPour 3.5 (3.7 U.Sqt) of the recommended oil in the filler hole;
windowThe oil level should bevisible through the windowIf oil is not visible, add recommended oil until the oil level is
visible between the lines of the window 3Remove the Phillips-head screws securing the strainer; then remove the strainer
I NOTE: To service the oil strainer, see Section 3 4Place the oil strainer into position and secure with the Phillips-head
screws11Inspect the area around the drain plug and oil filter for leaksSTRAINER To check the oil strainer, use the following
procedure1Remove the skid plate2Remove the Phillips-head cap screws securing the oil strainer cap; then remove the capNote