2005 Arctic Cat ATVs factory service and repair manual, Page 35Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 35

8Install the engine drain plug and tighten to specificationsPour the specified amount of the recommended oil in the filler
and wait approximately one minute 11Unscrew the oil level stick and wipe it with clean cloth12Install the oil level stick
until the threads touch engine caseI NOTE: On the 400 auto1500 auto1650the oil To check the oil strainer, use the following
procedure1Remove the skid plate2Remove the cap screws securing the oil strainer cap; then remove the capAccount for the O-ring
level stick should not be threaded into the case for checking the oil levelI NOTE: On the 650 V-Twin, the oil level stick
should be threaded into the case for checking the oil level 13Remove the oil level stick; the engine oil level should be
above the illustrated "L" mark but not higher than the illustrated "F" mark- Do not over-fill the engine with oilAlways make