2005 Arctic Cat ATVs factory service and repair manual, Page 48Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 48

EInstall the wheelTighten to specifications 5Burnish the brake pads (see Burnishing Brake Pads in this section) Auxiliary
and attempt to move the ATV ARemove the wheelBRemove the cap screws securing the caliper to the bracket; then remove the
cotter pin securing the pads and remove the pads Brake Pedal ATV00881 2If the rear wheels are locked, it is adjusted properly3If
the rear wheels are not locked, it must be adjusted (set up)CInstall the new brake pads; then secure with the pin and cotter
pinSpread the cotter pinADJUSTING DSecure the caliper to the knuckle andor axle housing with the cap screwsTighten to specifications
To adjust (set up) the auxiliary brake, use the following procedureIRemoval of the right, rear wheel enhances access to the