2005 Arctic Cat ATVs factory service and repair manual, Page 53Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 53

I NOTE: Before removing the belt, note the markings (A) (or mark the belt using tape or marker) in order to reinstall in
of the belt between the drive clutch (C) and the driven pulley (D); then using ruler, check the belt deflection (A)Use maximum
force of kg (13 lb) on the rulerStandard belt deflection is 22-27 mm (0.87-1.06 in 2If belt width is below the service limit
of 28.8 mm (1.13 in or there is damage to the belt, it must be replacedINSTALLING INOTE: Be sure to install the belt in the
same direction as originally installedWhen installing new belt, direct the top of the lettering (A) toward the engine I NOTE:
If belt deflection is out of specifications, proceed to step 3If belt deflection is within specifications, proceed to step