2005 Arctic Cat ATVs factory service and repair manual, Page 54Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 54

8Check the position of the Belt Failure Detection Switch (A) and reset to the ON position (B) 4Disassemble the driven pulleySee
the shim pack thickness to increase belt deflection and decrease the shim pack thickness to decrease belt deflectionI NOTE:
For each 0.1 mm (0.004 in of shim pack change, belt deflection will change by approximately 1.45 mm (0.057 inShims are available
in the following sizes: 0.6 mm (0.024 in, 0.8 mm (0.031 in, 1.0 mm (0.039 in, and 1.4 mm (0.055 in 10Connect the actuator
lead and the Belt Failure Detection Switch lead; then install the air duct and secure with the clamps 7Assemble the driven