2005 Arctic Cat ATVs factory service and repair manual, Page 65Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 65

Table of Contents Removing Engineflransmission 3-11 Top-Side Components -14 Removing Top-Side -14 Left-Side Components 3-17
the exhaust pipe from the muffler and the frame; then remove the exhaust pipeAccount for grafoil gasketsMark the position
of the hillow range shifter arm; then remove the hillow range shifter arm Removing Engine Transmission Many service procedures
can be performed without removing the engineltransmission from the frameClosely observe the note introducing each sub-section
for this important information W AT THIS POINT If the technician's objective is to servicelreplace left-side cover oil seals
(3), front output joint oil seal (I), rear output joint oil seal (I), andlor the oil strainer (from beneath the engine1 transmission),
the engineltransmission does not have to be removed from the frame 9Mark the gear shifter arm; then remove the cap screw
securing the gear shifter arm Secure the ATV on support stand to elevate the wheels Make sure the ATV is solidly supported