2005 Arctic Cat ATVs factory service and repair manual, Page 84Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 84

2Remove the valve seal and the lower remaining spring seatDiscard the valve seal Measuring Valve Stem Outside Diameter 1Using
Face Radial Runout 3Remove the valve springs; then invert the cylinder head and remove the valvesMeasuring Valve Stem Runout
1Mount dial indicator on the surface plate; then place the valve stem on set of blocks 1Support each valve stem end with
the Blocks (pln 0644-022); then check the valve stem runout using dial indicator 2Position the dial indicator contact point
on the outside edge of the valve face: then zero the indicator- ATVI 082; ATV-108: 2Maximum runout must not exceed specifications