2005 Arctic Cat ATVs factory service and repair manual, Page 90Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 90

Cleaningllnspecting Cylinder 1Wash the cylinder in parts-cleaning solvent2Inspect the cylinder for pitting, scoring, scuffing,
oilThoroughly clean cylinder after honing using soap and hot waterDry with compressed air; then immediately apply oil to
the cylinder boreIf the bore is severely damaged or gouged, replace the cylinder Water or parts-cleaning solvent must be
used in conjunction with the wet-or-dry sandpaper or damage to the sealing surface may result Inspecting Cam Chain Guide
1Inspect cam chain guide for cuts, tears, breaks, or chips2If the chain guide is damaged, it must be replacedHoning Cylinder
4If any measurement exceeds the limit, hone the cylinder and install an oversized piston or replace the cylinderI NOTE: Oversized
piston and rings are availableThe oversized piston and rings are marked for identification 1Using slide gauge and dial indicator
or snap gauge, measure the cylinder bore diameter in three locations from top to bottom and again from top to bottom at 90'
from the first measurements for total of six measurementsThe trueness (out-of-roundness) is the difference between the highest