2005 Arctic Cat ATVs factory service and repair manual, Page 94Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 94

2Inspect the springs and ratchet for wear or damage 5Align the inner hook of the spiral spring with the notch in the reel
must seat evenly in the recoil case 6Install the ratchet onto its pin making sure the end is properly installed on the reel
7Install the shaft, spring, and the spring cover 2Insert the rope through the hole in the reel and tie knot in the end; then
wrap the rope counterclockwise around the reel leaving approximately 50 cm (20 in of rope of the reel 3Apply low-temperature
grease to the spring and hub4Thread the end of the rope through the guide hole of the case; then thread the rope through