2005 Arctic Cat ATVs factory service and repair manual, Page 95Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 95

MEASURING SHIFT FORK (Thickness) W NOTE: Whenever shift fork is out of tolerance, replacement is necessary I Using calipers,
the reel four turns counterclockwise; then release the rope f?om the notch and allow the rope to retract12Pull the rope out
two or three times to check for correct tensionNOTE: Increasing the rotations in step will increase spring tension 13Place
the gasket and recoil starter assembly into position on the left-side cover noting the location of the single washer; then
tighten the cap screws to specifications 2Shift fork groove width must be specificationsMEASURING SHIFT FORK TO GROOVE (Side