2005 Arctic Cat ATVs factory service and repair manual, Page 96Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 96

1Inspect each driven plate for warpage and burn marks2In turn place each driven plate on the surface plate; then using feeler
W NOTE: Prior to inspecting and measuring components, it is recommended that all components be removed from the primary gear
assembly and be cleaned InspectingIMeasuring Clutch Driven Plate Warpage W NOTE: After removing the clutch hub and clutch
plates, account for the washer beneath the clutch hub 2Drive plate thickness must not exceed minimum specifications 3If the
fiber plate tabs are damaged, the plate must be replaced4Inspect the clutch hub for grooves or notchesIf grooves or notches
are present, replace the hubW NOTE: Note the location of the timing mark on the hub for assembly purposes Arctic Cat ATV