2005 Arctic Cat ATVs factory service and repair manual, Page 112Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 112

5Press the 2nd drive gear onto the countershaft leaving an 0.25 mm (0.010 in gap between the 2nd and 5th drive gearsINOTE:
bushing, reverse idler gear, and spacer Assembling Crankcase Half I NOTE: For ease of assembly, install components on the
right-side crankcase half INOTE: The shoulder of the reverse idler gear should be directed away from the crankcase INOTE:
If the output shaft was removed, make sure that the proper shim is installed 1Place the oil pipe in position and secure to
the crankcase with the Phillips-head screws coated with red Loctite #2712Apply liberal amount of engine oil to the right-side
crankshaft bearingUsing propane torch, heat the bearing until the oil begins to smoke; then slide the crankshaft assembly