2005 Arctic Cat ATVs factory service and repair manual, Page 116Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 116

7Apply small amount of grease to the O-ring seal on the starter; then install the starter into the crankcaseSecure with two
pump was serviced, follow steps 1Place the oil pump into position on the crankcase and secure with the Phillips-head screws
coated with blue Loctite #243Tighten to specifications 4Noting the arrow from disassembly, place the strainer cap into position
on the crankcase making sure the O-ring is properly installed and secure with the cap screws; then tighten the oil drain
plug to specifications 2Place the pin into position on the oil pump shaft, install the oil pump driven gear making sure the
recessed side of the gear is directed inward, and secure with new circlip 5Place the stopper plate pins into position noting