2005 Arctic Cat ATVs factory service and repair manual, Page 118Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 118

12Using clutch sleeve hub holder, install the nut and washerTighten to specifications 10Install the primary driven washer
NOTE: After placing the primary clutch assembly onto the countershaft, pull out on the pressure plate tower ensure the pressure
plate has engaged the clutch hub properly and make sure the plates (drive and driven) are brought together tightly prior
to tightening the nut securing the primary clutch assembly 15Install the release roller assembly making sure the four springs
are in position; then using crisscross pattern, tighten the four cap screws securelyINOTE: Tighten the four roller assembly
cap screws in crisscross pattern making sure there is no clearance between the clutch plates when secured 16Slide the clutch