2005 Arctic Cat ATVs factory service and repair manual, Page 122Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 122

12Place the drive gear and washer on the driveshaft 13Install the driven gear and washer (4x4) 14Install the cam chain: then
in place 17Install the magneto rotor nut on the crankshaft and tighten until the rotor is properly seated; then tighten to
specifications 16Install the starter idler gear and shaft; then install the spacer 18Place the gasket and left-side cover
into position on the crankcase making sure the alignment pins are in place19Install the cap screws to secure the left-side