2005 Arctic Cat ATVs factory service and repair manual, Page 123Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 123

20Place the starter cup into position on the crankshaft making sure new, lubricated O-ring is inside the cupTighten the nut
end gaps of the upper and lower thin oil rings according to the illustrationAn is stamped on the piston to indicate frontFront
22Place the gasket and recoil starter assembly into position on the left-side cover noting the location ofthe single washer;
then tighten the cap screws to specifications # Compression i Ring End Gap Oil Ring Expander End Gap ATV-10851 I NOTE: Note
the direction of the exhaust side of the piston (5) for correct ring end gap orientation BInstall the compression rings (1
and 2) so the letter on the top surface of each ring faces the dome of the pistonRotate the rings until the ring end gaps