2005 Arctic Cat ATVs factory service and repair manual, Page 126Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 126

8Install the three cylinder head cap nuts and one nut with copper washers (note the locations of the cap nuts and nut)Tighten
(from step 8) to specificationsTighten the remaining head nuts (from step 8) and the cylinder-to-crankcase nuts (from step
4) to specifications11Place the C-ring into position in its groove in the cylinder head I NOTE: Note the position of the
alignment marks on the end of the camshaftThey must be parallel with the valve cover mating surfaceIf rotating the camshaft
is necessary for alignment, do not allow the chain and sprocket to rotate and be sure the cam lobes end up in the down position