2005 Arctic Cat ATVs factory service and repair manual, Page 127Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 127

14When the camshaft assembly is seated, ensure the followingAPiston still at top-dead-centerBCamshaft lobes directed down
the sprocket to the camshaft can be installed; then install the cap screw (threads coated with red Loctite #271) and tighten
to specificationsBend the tab to secure the cap screw18Rotate the crankshaft until the first cap screw (from step 16) securing
the sprocket to the camshaft can be addressed; then tighten to specificationsBend the tab to secure the cap screwIMake sure
to return the timing mark to TDC on the compression stroke 19Install the cylinder head plug in the cylinder head20Remove
the cap screw from the end of the chain tensionerAccount for the plunger, spring, and O-ring Care must be taken that the
tab washer is installed correctly to cover the alignment hole on the sprocketIf the alignment pin falls out, severe engine