2005 Arctic Cat ATVs factory service and repair manual, Page 129Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 129

FWhile holding the adjuster dial at the proper clearance setting, tighten the jam nut securely with the valve adjuster handle;
the valve adjuster dial in place, use the valve adjuster handle and loosen the jam nut; then rotate the tappet adjuster screw
clockwise until resistance is felt Installing EngineITransmission NOTE: Arctic Cat recommends that new gaskets and O-rings
be installed whenever servicing the ATV DAlign the valve adjuster handle with one of the marks on the valve adjuster dialEWhile
holding the valve adjuster handle in place, rotate the valve adjuster dial counterclockwise until specified valveltappet
clearance is attainedNOTE: Rotating the valve adjuster dial counterclockwise will open the valveltappet clearance by 0.05
mm (0.002 in per mark Install the engine into the sub-frame assemblyConnect each drive axle to the engine output shaftsSecure