2005 Arctic Cat ATVs factory service and repair manual, Page 133Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 133

Table of Contents (400 - Manual Transmission) 3Near the battery tray, remove the two screws securing the fuse block; then
Transmission Many service procedures can be performed without removing the engineltransmission from the frameClosely observe
the note introducing each sub-section for this important information Drain Plug View from Beneath 6Remove the hardware securing
the right-side and left-side panels; then remove the panels AT THIS POINT If the technician's objective is to servicelreplace
left-side cover oil seals (31, front output joint oil seal (I), rear output joint oil seal (I), andlor the oil strainer (from
beneath the engine1 transmission), the engineltransmission does not have to be removed from the frame 7Turn the gas tank
valve to the OFF position; then remove the fuel hose and vent hose8Remove the gas tank Secure the ATV on support stand to
elevate the wheels Make sure the ATV is solidly supported on the support stand to avoid iniurv 1Remove the seat2Remove the