2005 Arctic Cat ATVs factory service and repair manual, Page 155Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 155

Removing Valves I NOTE: Keep all valves and valve components as setNote the original location of each valve set for use during
valve seal 1Using micrometer, measure the valve stem outside diameter 2Acceptable diameter range (intake valve) must be within
specifications 3Acceptable diameter range (exhaust valve) must be within specificationsMeasuring Valve FaceISeat Width 1Using
micrometer, measure the width of the valve face 2Acceptable width specifications Measuring Valve Face Radial Runout I NOTE:
The valve seals must be replaced 1Mount dial indicator on the surface plate; then place the valve stem on set of blocks 3Remove