2005 Arctic Cat ATVs factory service and repair manual, Page 165Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 165

Cleaning and Inspecting W NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
handle and pull the rope out of the handle; then untie the knot in the rope and remove the handlemNOTE: Do not remove the
spiral spring unless replacement is necessaryIt should be visually inspected in place to save timeIf replacement is necessary,
follow steps 9-10 9Remove the spiral spring from the case by lifting the spring end up and outHold the remainder of the spring
with thumbs and alternately release each thumb to allow the spring to gradually release from the case10Unwind the rope from
the reel and remove the rope 2Insert the rope through the hole in the reel and tie knot in the end; then wrap the rope counterclockwise
around the reel leaving approximately 50 cm (20 in of rope free of the reel 3Apply low-temperature grease to the spring and
hub4Thread the end of the rope through the guide hole of the case; then thread the rope through the handle and secure it