2005 Arctic Cat ATVs factory service and repair manual, Page 171Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 171

Servicing Center Crankcase Components cracked, damaged in any way, or out of tolerance, replacement is necessaryI NOTE: Whenever
crankcase half 2Clean the secondary driven bevel gear teeth of old oil and grease residue3Apply thin, even coat of machinist-layout
dye toseveral teeth of the gear4Install the secondary driven output shaft assembly- 1Place the left-side crankcase cover
onto the left-side crankcase half to prevent runout of the secondary transmission output shaft2Install the secondary driven
output shaft assembly onto the crankcase3Mount the indicator tip of the dial indicator on the secondary driven bevel gear4While
rocking the driven bevel gear back and forth, note the maximum backlash reading on the gauge5Acceptable backlash range is
0.05-0.33 mm (0.002-0.013 inCorrecting Backlash INOTE: If backlash measurement is within the acceptable range, no correction
is necessary 5Rotate the secondary driven bevel gear several revolutions in both directions6Examine the tooth contact pattern