2005 Arctic Cat ATVs factory service and repair manual, Page 172Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 172

Correct 2Maximum diameter specifications Measuring Connecting Rod (Small End Deflection) 1Place the crankshaft on set of
and crankshaft journal Contacts at TOD Contacts at Root Decrease Shim Thickness Increase Shim Thickness ITo correct tooth
contact, steps and (with NOTE) of "Correcting Backlash" must be followed and the above "Tooth ContactIShim Correction" chart
must be consulted A CAUTION After correcting tooth contact, backlash must again be checked and corrected (if necessary)Continue
the correcting backlashlcorrecting tooth contact procedures until they are both within tolerance values CRANKSHAFT ASSEMBLY
Measuring Connecting Rod (Small End Inside Diameter) 3.Acceptable gap specifications Measuring Connecting Rod (Big End Width)
1Insert snap gauge into the upper connecting rod small end bore; then remove the gauge and measure it with micrometer 1Using
calipers, measure the width of the connecting rod at the big-end bearing 2Acceptable width specifications Page: 172 Arctic