2005 Arctic Cat ATVs factory service and repair manual, Page 186Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 186

5From the left side, install the seven case half mm cap screws; then tighten only until snugINOTE: Rotate the shafts back
and forth to ensure no binding or sticking occurs 8In crisscrosscase-to-case pattern, tighten the mm cap screws (from steps
5-6) to specificationsINOTE: Rotate the shafts back and forth to ensure no binding or sticking occurs 3Place the oil pump
into position in the crankcase and secure with the three Phillips-head screws coated with blue Loctite #243Tighten to specifications
After completing center crankcase components, proceed to Installing Right-Side Components, to Installing Left-Side Components,
and to Installing Top-Side Components Installing Right-Side Components AOil Strainerfoil Pump BGear Shift Shaft 4Place the
washer and pin into position on the oil pump shaft, install the oil pump driven gear, and secure with the circlipINOTE: Always