2005 Arctic Cat ATVs factory service and repair manual, Page 192Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 192

11Install starter idler gear #2 and shaft with the chamfered side directed toward the crankcase I NOTE: Make sure that three
Starter I NOTE: Steps 1-13 in the preceding sub-section must precede this procedure 14Place the gasket and left-side cover
into position on the crankcaseINOTE: It may be necessary to push or pull the splined HiILow range shift shaft to establish
coverlcrankcase mating 15Install the fifteen mm cap screws and one mm cap screw to secure the left-side coverOnly finger-tighten
at this time 13Install the two alignment pins into the left crankcase half 16Place the gear shift stopper wlspring and washer