2005 Arctic Cat ATVs factory service and repair manual, Page 196Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 196

6Place the head gasket into position on the cylinderPlace the alignment pins into position; then place the head assembly
washer 7Install the four cylinder head cap screws with washersNote that the two cap screws on the right side of the cylinder
head nearest the cam sprocket are longer than the two cap screws on the left (spark plug) sideTighten only until snug12With
the alignment pin installed in the camshaft and the cam lobes directed down (toward the piston), place the camshaft in position
and verify that the timing mark on the magneto is visible through the inspection plug and that the timing marks on the camshaft
sprocket are parallel with the valve cover mating surfaceI NOTE: When the camshaft assembly is seated, make sure the alignment
pin in the camshaft aligns with the smallest hole in the sprocket 13Loosely place the cam sprocket (with the recessed side