2005 Arctic Cat ATVs factory service and repair manual, Page 199Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 199

28In crisscross pattern starting from the center and working outward, tighten the cap screws (from step 27) to specifications29Adjust
making sure the two alignment pins are properly positionedIAt this point, the rocker arms and adjuster screws must not have
pressure on them 27Install the four top-side cap screws with rubber washers; then install the remaining cap screwsTighten
only until snugCWhile holding the valve adjuster dial in place, use the valve adjuster handle and loosen the jam nut; then
rotate the tappet adjuster screw clockwise until friction is felt DAlign the valve adjuster handle with one of the marks
on the valve adjuster dial EWhile holding the valve adjuster handle in place, rotate the valve adjuster dial counterclockwise