2005 Arctic Cat ATVs factory service and repair manual, Page 203Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 203

25Install the battery in the tray, install the vent hose, and secure the battery with the hold-down strapConnect the positive
(fi-om step 18) to specifications20Install the rear fenders and the rear rack (see Section 8)21Install the gas tank (see
Section 4)22Place the right-side and left-side panels into position; then install the existing hardware and tighten securely23Carefully
guide the battery cables and fuse block wiring up through the access hole into the battery tray24Connect all fuse block wiring
according to the marking made in removing; then place the fuse block into position and secure with two screws (see wiring
diagram in Section 5) -lf the engine had major overhaul or if any majo; part was replaced, proper engine break-in procedures
must be followed (see SectionIf the proper engine break-in procedures are not followed, severe engine damage may result Table
of Contents (400 Automatic Transmission) It is critical that all wiring be installed correctly to ensure electrical components