2005 Arctic Cat ATVs factory service and repair manual, Page 206Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 206

INOTE: It is not necessary to remove the front fender to remove the engine; however, removing the screws securing the inner
drain pan beneath the hoses prior to removing the oil hosesI NOTE: There will be substantial amount of oil II 1CC568 22Renioe
the hardware securingthe rear drieshal't 26Disconnect the top connector at the CDI unit I NOTE: It is advisable to lock the
brake when loosening the cap screws securing the rear driveshaft 23On the right side, cut the cable ties securing the wiring
harness to the frame 27Disconnect the stator-to-rectifierlregulator connector 28Remove the temperature sensor wires from
the engineI NOTE: There are two temperature sensors 24Remove the positive cable from the starter motor and route it out of