2005 Arctic Cat ATVs factory service and repair manual, Page 207Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 207

37Loosen the hose clamps securing the front and rear duct boots to the engine; then remove the boots Remove the cap screw
rotating the engine counterclockwiseThe engine will come out the right side of the frame Top-Side Components 35Remove the
caps screws securing the two upper rear engine mounts to the frameI NOTE: For efficiency, it is preferable to remove and
disassemble only those components which need to be addressed and to service only those componentsThe technician should use
discretion and sound judgment 36Slightly raise the front of the engine to disengage the front driveshaft from the front output
yoke c AT THIS POINT To service any one specific component, only limited disassembly of components may be necessaryNote the